Construction steps for laying out covered optical cables and general technical requirements for laying out 1. Determine the laying route of covered optical cables, and investigate whether there are available supports for laid outdoor covered optical cables on the route. Generally, each The support can fix 8 outdoor optical fiber cables.
2. Select supports and their installation locations based on the principles of firm installation, even spacing, and ease of maintenance.
3. Use steel straps and clamps to fix the hooks on the poles; use expansion screws and screws to fix the C-shaped hooks on the exterior walls. For wooden exterior walls The ring hook can be fixed directly on it.
4. Separate the hanging wire of the outdoor covered optical cable and tie the hanging wire Tie it to the S fixing piece, and then hang it on the supporting piece. When the length of the leather optical cable to be laid exceeds 100 meters, it is advisable to start laying it out from the middle point.5. Use a longitudinal wrapping tube to wrap the excess length of the outdoor leather optical cable where the hanging wire and the S fixing piece are bound.
6. The intersection between outdoor covered optical cables and other cables should be wrapped and protected with winding tubes.
7. It is strictly forbidden to step on or block the outdoor covered optical cable during the entire cabling process. If the outdoor covered optical cable is found to be damaged, consider re-laying it.
