The fusion splicer is a relatively durable equipment.
Usually, with proper maintenance, a Fujikura fusion splicer can last more than ten years.
After such a long time, it is not surprising that there are some glitches.
Next, Xiaowei will list several common faults and problems of welding machines Solution, I hope it will be helpful to everyone
< /p>
1No response when booting, no sound, no display light
Analysis
A. First check the power supply, whether the battery still has power, whether the power adapter is connected, etc. The fusion splicer that has been left for a long time will also consume power.
B. Keyboard failure or internal motherboard failure.
Solution
If it is situation A, you can try to charge it. If it cannot be charged, you can try to replace the charger and battery of the same model. If the problem cannot be solved after trying, then it means that it is situation B, and you can only report it for repair. It is not recommended to disassemble it by yourself
2X /Y One side is bright and the other is dark, or both sides are dark
Analysis
A. There is too much dust on the surface of the objective lens, blocking light.
B. The sensing system is faulty and the LED light does not turn on automatically.
C. The CCD (imaging system) inside the fusion splicer is damaged or malfunctioned.
Solution
In case A, just clean the dust on the surface of the objective lens. If it cannot be solved, it may be case B or C and you need to report for repair.
< p>It is not recommended to disassemble it by yourself without professional skills. 3 The optical fibers on the left and right or on either side do not advance during splicing
Analysis
A. The prepared optical fiber is very fragile and easy to break, resulting in insufficient motor stroke.
B. The left and right sheath pressure plates of the machine cannot fasten the optical fiber properly.
C. Internal motor or other failure of the machine.
Solution
CheckCheck the optical fiber. If the optical fiber is broken, it is situation A. Just prepare the optical fiber again.
To solve situation B, you need to check the fixation of the sheath pressure plate of the fusion splicer, check whether it is a pressure plate problem or an optical fiber problem, and determine whether loose tube optical fiber is used. Loose tube optical fiber needs an adapted clamp. to tighten.
If it is not a loose tube fiber, twitch the fiber again to confirm whether the sheath pressure plate can tighten the fiber. If not, replace the sheath pressure plate.
If none of the above conditions are met, it is situation C and needs to be reported for repair. It is also not recommended to disassemble the machine yourself to solve the problem.
4 When the optical fiber moves up and down during splicing, the two ends are not aligned
Analysis
There is dust in the A.V-shaped groove, which causes the position of the fiber on one side to be higher, which is greater than the maximum value of the up and down movement of the fiber on the other side.
B. The optical fiber presser foot on the windproof cover is dirty or the V-groove is stuck and cannot spring up normally, causing the optical fiber to fail during advancement. Pressed.
C. The stroke of the V-shaped groove inside the machine is misaligned.
p>Solution
Use a fine cotton swab dipped in alcohol to wipe the V-shaped groove and fiber optic presser foot back and forth. If the problem cannot be solved, report it for repair directly.
< p>5 cannot be heated or can be heated manually but cannot be heated automatically
Analysis
A. The automatic heating function of the machine is not turned on.
B. The machine's automatic heating sensor is stuck.
C. The machine heating key is damaged.
D. The machine's internal heater is faulty.
Solution
Set up the automatic heating function inside the machine.
If the problem cannot be solved, please report it for repair and do not disassemble the machine yourself.
